Simplify product selection with The V – EDGE Personal Fall Limiter. The V – EDGE is engineered for use in overhead and foot-level tie off points, and where leading edge hazards are a concern. With a stainless steel housing built to last in the toughest environments, this PFL .
Leading edge fall protection personal fall limiter provides lower cost of ownership with a stainless steel housing. Built to last in the toughest environments, saving time and money on replacements.
6/11/2018 · Our first web unit for leading edge fall protection see it in action here! Learn more at http://us.msasafety.com/leadingedgefallprotection, The V – EDGE Personal Fall Limiter is engineered for use in overhead and foot-level tie off points, and where leading edge hazards are a concern. The V – EDGE meets ANSI Z359.14-2014 and EN 360:2002, VG11 CNB/P/11.060 Leading Edge Requirements.
MSA V – EDGE ™ Mini Personal Fall Limiter V – EDGE , Leading Edge PFL , 1.8m, Webbing, Twin-Leg, Aluminum Swivel Scaffolding Hook, The device has been successfully tested for horizontal use over a steel edge without burrs using the methods in VG11 CNB/P/11.060 ( edge type A – 0.5 mm). The V – EDGE Mini PFL is also specifically tested and suitable for use on Mobile Elevating Working platforms (DIN 19427:2017-04, a peak force at the anchor point below 3kN).
MSA V – EDGE . TM. WEB 8ft/2.4m PFL . October 30, 2019 . Dear MSA Fall Protection Customer, MSA is issuing this Inspection Notice to inform you that MSA has received a limited number of field reports in which the lifeline in a WORKMAN MINI PFL did not retract after being fully extended. MSA has not received any reports of injuries associated with …
Simplify product selection with The V – EDGE Personal Fall Limiter. The V – EDGE is engineered for use in overhead and foot-level tie off points, and where leading edge hazards are a concern. With a stainless steel housing built to last in the toughest environments, this PFL .
The device has been successfully tested for horizontal use over a steel edge without burrs using the methods in VG11 CNB/P/11.060 ( edge type A – 0.5 mm). The V – EDGE Mini PFL is also specifically tested and suitable for use on Mobile Elevating Working platforms (DIN 19427:2017-04, a peak force at the anchor point below 3kN).
